Carbide Tipped Straight Shank One-Piece Design for Rotary Only drilling for cutting metal rebar embedded in concrete. 11" Usable Length. Rebar Cutters are used to cut holes through embedded steel reinforcing bar found in concrete.
Carbide Tipped Straight Shank One-Piece Design for Rotary Only drilling for cutting metal rebar embedded in concrete. 11" Usable Length. Rebar Cutters are used to cut holes through embedded steel reinforcing bar found in concrete. They are used to prevent damage to the masonry hammer bit, which cannot cut through a metal rebar and will be damaged if the hammer bit is used when rebar is encountered. Once embedded rebar has been successfully cut with the rebar cutter bit immediately remove the rebar cutter bit and continue drilling the hole using your carbide masonry hammer drill bit. Relton rebar cutter bits must only be used on the Rotary Only setting on the drill motor.
Specifications
Manf Part Number
RB-10
UPC
78540111001
Condition
New
Weight
0.750000
Features
Drills through the rebar without having to relocate the hole in order to avoid the rebar
Designed to drill dry, no water or coolant is needed
Use in standard 1/2" drill motor
Straight Shank has 3-flats to eliminate slippage in 3-jaw chuck.
Skid Count
0
Prop 65 Warning
Warning
This product can expose you to a chemical (or chemicals) that are known to the State of California to cause cancer or reproductive harm. For more information go to www.P65Warnings.ca.gov